GCSE Computer Science Grade Boundaries (OCR J277) by Year
OCR GCSE Computer Science (J277) grade boundaries for 2023, 2024 and 2026 out of 160, with percentages, why they change, and how to use them for mocks.
By Yuness, qualified Computer Science teacher and former Head of KS5 Computer Science · Last reviewed 21 November 2026
For OCR GCSE Computer Science (J277), the overall grade boundaries are set on a total of 160 marks (two papers of 80 marks each). In June 2026 a grade 4 needed 77 marks, a grade 7 needed 124 and a grade 9 needed 141. These numbers move every year: a grade 4 needed only 63 marks in June 2023 and 72 in June 2024, because boundaries are reset each series to reflect how hard the papers were. Use them to see roughly where you stand, not as a fixed target.
OCR GCSE Computer Science (J277) grade boundaries by year
The table shows the overall (qualification-level) boundaries, out of 160 raw marks, taken from OCR's published GCSE grade boundary documents for each June series. Each figure is the minimum total mark needed for that grade.
| Grade | June 2026 (out of 160) | June 2024 (out of 160) | June 2023 (out of 160) |
|---|---|---|---|
| 9 | 141 | 136 | 133 |
| 8 | 132 | 126 | 119 |
| 7 | 124 | 117 | 106 |
| 6 | 108 | 102 | 91 |
| 5 | 92 | 87 | 77 |
| 4 | 77 | 72 | 63 |
| 3 | 56 | 52 | 46 |
| 2 | 35 | 32 | 29 |
| 1 | 14 | 13 | 12 |
Sources: OCR "GCSE (9-1) qualification and notional component raw mark grade boundaries" documents for the June 2023 series (first published 24 August 2023), June 2024 series (first published 22 August 2024) and June 2026 series (first published 20 August 2026). OCR has since issued minor corrections to each document, none affecting J277. The official place to check them is OCR's grade boundaries page. June 2022 and June 2025 are not shown here because I could not check them against the official documents while writing this; I will add them once I have.
The same boundaries as percentages
Percentages make the years easier to compare (mark ÷ 160 × 100, rounded to one decimal place):
| Grade | June 2026 | June 2024 | June 2023 |
|---|---|---|---|
| 9 | 88.1% | 85.0% | 83.1% |
| 7 | 77.5% | 73.1% | 66.3% |
| 5 | 57.5% | 54.4% | 48.1% |
| 4 | 48.1% | 45.0% | 39.4% |
Across these three years, the grade 4 boundary ranged from 63 to 77 marks, a 14-mark difference. At grade 7 the difference was 18 marks (106 to 124). That spread is why a single year's boundary is a poor target.
Paper-by-paper (notional) boundaries for June 2026
OCR also gives boundaries for each paper. In June 2026 they were:
| Paper | Max mark | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 |
|---|---|---|---|---|---|---|---|---|---|---|
| J277/01 Computer systems | 80 | 72 | 67 | 63 | 55 | 48 | 41 | 29 | 18 | 7 |
| J277/02 Computational thinking, algorithms and programming | 80 | 69 | 65 | 61 | 53 | 44 | 36 | 27 | 17 | 7 |
OCR's document explains that these paper-level (notional) boundaries show what the grade would be if grades were given for each paper, and that grades at paper level don't automatically add up to the same grade overall. Your grade comes from your total mark across both papers, so a weaker Paper 1 can be balanced by a stronger Paper 2. You do not need to "pass" each paper separately.
Why do grade boundaries change every year?
Ofqual's student guide to exams in 2026 explains that boundaries move to reflect how hard each year's exam is. The aim is that a grade is no easier or harder to get from one year to the next. Exam boards set the boundaries after marking. Ofqual says there are no quotas for how many students must pass or fail, and no cap on how many can get each grade.
In practice, if a paper turns out to be harder, the boundaries go down. If it turns out to be easier, they go up. A higher boundary in 2026 does not mean the 2026 students were treated more harshly. It means examiners judged the same quality of work to be worth more marks on those papers. Ofqual's guide to the 9 to 1 grade scale says grading uses both data and examiner judgement.
2022 and 2023: the return to normal grading after the pandemic
OCR's J277 specification was first examined in 2022, so the early years of this specification overlap with the return to exams after COVID-19:
- 2022: Ofqual said grading was lenient, "a staging post between 2021 and 2019 grades". It added that boundaries were generally lower than in 2019, though not all of them, because boundaries also reflect how difficult each paper was.
- 2023: Ofqual said grading went back to pre-pandemic standards, but with protection for students: allowances were made where national performance was weaker than before the pandemic. It also noted that some boundaries were lower than in 2019 and others higher.
Because of this, avoid comparing 2022 or 2023 boundaries too closely with later years. The papers were different, and so was the grading context.
What grade boundaries mean for your mocks
Boundaries are useful for mocks, but only if you use them carefully. My advice as a teacher:
- Use a range, not one number. If your total sits between the lowest and highest grade 6 boundaries in the table, you are working at about a 6. That is more honest than picking the year that flatters you or the year that scares you.
- Match the paper to its own year where you can. A June 2024 paper marked against June 2024 boundaries tells you more than the same paper marked against 2026 boundaries.
- Remember when you sat it. A mock in Year 11 is taken months before the real exam, often before you have finished revising. A mock grade shows where you are now, not where you will finish.
- Aim above the boundary. If you need a 7, aiming for exactly last year's grade 7 mark leaves no margin. Aim to be comfortably over it.
- Look at the marks you dropped, not just the grade. Work out which topics and question types lost you marks. That tells you what to revise next. Our GCSE Computer Science hub is organised by topic for exactly this.
For full papers to practise with, see our OCR J277 past papers page, which links to the official papers and mark schemes.
How to turn your mark into a percentage (and a grade)
- Add up your marks from both papers. Each J277 paper is out of 80, so the total is out of 160.
- Divide by the total and multiply by 100. For example, 77 out of 160 is 77 ÷ 160 × 100 = 48.1%.
- Compare against the table. 77 marks would have been exactly a grade 4 in June 2026, a grade 5 in June 2023 and a grade 4 in June 2024.
- If you only sat one paper, compare it against that paper's notional boundaries (out of 80) instead, and treat the result as a rough guide.
OCR A Level (H446) and Cambridge IGCSE (0478) boundaries
This post covers OCR GCSE (J277) only. If you take OCR A Level Computer Science (H446), check OCR's grade boundaries page. For Cambridge IGCSE Computer Science (0478), use Cambridge International's official grade threshold tables for the series you are looking at. In both cases, converting marks to percentages is the easiest way to compare years.
I have not included H446 or 0478 figures in this post yet because I could not check them against the official documents while writing it. I will add them once checked. Until then, use the official documents, and find past papers through our OCR A Level Computer Science past papers page (with topic guides on the OCR A Level hub) and our Cambridge IGCSE Computer Science past papers page.
FAQ
When are GCSE Computer Science grade boundaries published?
On results day. OCR's GCSE boundary documents were first published on 24 August 2023, 22 August 2024 and 20 August 2026, and Ofqual confirms these were the GCSE results days in those years. For 2027, JCQ's key dates for the June 2027 series (as of November 2026) list Thursday 19 August 2027 as the release of results to candidates for GCSE (and Level 1 and 2 Projects), so that is when the June 2027 boundaries should appear.
What mark do I need for a grade 4 in OCR GCSE Computer Science?
It changes every year. In June 2026 it was 77 out of 160 (48.1%). In June 2024 it was 72, and in June 2023 it was 63. Ofqual says the bottom of a grade 4 is comparable to the bottom of the old grade C.
Do I have to pass both papers?
No. Your grade comes from your combined total out of 160. OCR's paper-level boundaries are notional: they show how you did on each paper, but your final grade is set by your total mark.
Will the 2027 boundaries be the same as 2026?
Nobody knows until results day. Boundaries are set after the papers are marked and depend on how difficult those papers turned out to be. Plan to beat the higher end of recent boundaries rather than relying on one year.
Are grade boundaries a quota, so only a set number of students get each grade?
No. Ofqual says there are no quotas and no cap on how many students can get each grade. The aim is that the standard needed for each grade stays comparable from year to year.
If your mock result was not what you hoped, the gap between grades is usually a few topics and some exam technique. Start with the free guides on our GCSE hub. If you would like a teacher to look at your mock and build a plan with you, you can book a free 1-hour trial lesson.